2016年7月18日星期一

Tacho Pro 2008 July PLUS Universal Dash Programmer Odometer Correction on Citroen Model Xsara

Tacho Pro 2008 July PLUS Universal Dash Programmer Odometer Correction on Citroen Model Xsara

Preparation:

Tacho Pro 2008 July PLUS Universal Dash Programmer

Use this board and clip:



Operation Steps:

• Remove the cluster and open it.
• Remove the motors carefully from the circuit board. Do not pull off the needles!!!
• Look for the 8 pin chip 93C46.
• Look for the silver chrystal and join its contacts.
• Connect the clip to Port 1.
• Put the clip on the chip 93C46 (red on pin 1).
• Select the menu: Citroen-Xsara
• The Tacho Universal shows you the old value.
• Select the menu Adjust KM.
• Enter the new value.
• Verify the new value with OK.

2016年7月6日星期三

Tacho Pro 2008 July PLUS Universal Odometer Correction on Ford Focus Step by Step

Tacho Pro 2008 July PLUS Universal Odometer Correction on Ford Focus Step by Step

Tacho Pro 2008 July PLUS Universal is one French favorite device to do mileage correction. It can do multi-brand cars than the other tool. See the procedure to do on Ford Focus bellow:

Use the Scorpio plug:


26pin white port

1.Pin 2      GND(-)          black
2.Pin 9      RX (Data)       blue
3.Pin 11     TX (Data)       yellow
4.Pin 14     12V (+)         red
5.Pin 16     12V (+)         red

Processor version 1:
• Connect Pin 1 ( left side down) and pin 2 (right from pin 1), or connect black to test point 3 (TP3).



Processor version 2:
• Connect pin 1 (middle upside) and pin 2 (left beside pin 1), or connect black to testpoint 46 (TP46).


• Remove the cluster and open it.
• Connect the cables as shown in the picture.
• Select the menu Ford-Focus
• The Tacho Pro 2008 July PLUS Universal shows you the old value.
• Enter the new value.
• Verify the new value with OK.